Notifications
Clear all
28/02/2012 8:31 pm
These are the dBi values of the probe which change every 10MHz.
You can avoid those by using dBm instead of field strength.
Snip
Topic starter
29/02/2012 8:14 am
But I was already measuring dBm as you can see on the vertical axis.
29/02/2012 3:38 pm
You also have to remove the antenna calibration setup.
Snip
Topic starter
29/02/2012 3:57 pm
I did not have any calibration settings set.
01/03/2012 9:27 pm
In this case it is simply the noise level test which is done every 10MHz to give you more dynamic.
Snip
Share: